Peptide Hormone Melanotan II ( Melanotan 2 ) 10mg Injection MT2

Quick detail
 

Melanotan II information 

MT-2 is sold and transported as 10mg freeze dried powder in sterile sealed, multi use vials. It requires reconstitution with sterile water before it can be used. This is done at home because after reconstitution vial has to be kept in fridge or will slowly start to degrade (become less effective).

Reconstituting tanning peptide is a part of the process required for use of the product and will require full attention to get proper results. 1 or 2ml sterile water is usually used, diluting with more water will improve dosing accuracy. Lovemelanotan peptide calculator is ideal tool for anyone just starting out and not sure how to reconstitute or dose the product properly.

Do not fall for the easier methods of using MT-2, injections is the only proper way of using this peptide. Many Internet suppliers will sell things like nasal sprays, pre-mixed peptide, oral pills and powders, they simply don't work, if they did no one would use injections, right? There are a some positive reports of nasal spray experience, however its not very cost effective as peptide molecules in this form are large and difficult to pass the nasal membrance, there is some effect, but its minor comparable to injection route where absorption rate is 100%. Similarly, pills of this type are also quite useless because enzymes within the stomach will render the peptide inert.

Melanotan II benefit

Minimal UV Exposure: MT2 is not completely sunless tanner, it still requires exposure to sunlight to be effective, however it requires significantly less time to develop a tan than without the peptide.

Skin damage protection: Tan by the nature is designed to protects skin from uv ray damage, tan developed with the help of melanotan provides deep pigmentation to protect all skin layers.

Lasting Tan: Even if peptide use is stopped entirely, a warm tan can last for months on end without exposure to the sun. By contrast, tan developed naturally fade very quickly in a matter of days depending on persons skin type.

EQUIPMENT

Understanding Insulin Syringe:

Volume of insulin syringes is measured in IU (Internation Units)

100 IU = 1 ML

10 IU = 0.1 ML

Typically for reconstitution of 10mg peptide you will use 1ml (100iu on insulin syringe) of sterile water, which will give you ready to use liquid solution with concentration of 0.1ml (10iu) = 1mg. From this product concentration dosing is pretty straight forward.

10iu = 1mg

5iu = 0.5mg

3iu = 0.3mg and so on.

Melanotan II Dose

Injecting:

Actual injection can be done Subq or IM that is - subcutaneous or intramuscular. Injection site does not matter, there is no one site better than others so use one which is more comfortabe to reach, after injection product is absorbed into bloodstream and spread through the body evenly. Subq injection takes place by pinching the skin loose from the muscle and raising it so the needle can be inserted in the fat layer of skin.

Starting dose:

The first dosage should be fairly small, as little as 0.3mg in order to gauge the reaction of the user's body. With increased dose first time user will deel warming ensation, flush in face and mild nausea, if these side effects occure dosage can be taken before going to bed, so any unpleasant effects take place while user is asleep. With regular use these side effects disapper and product can be taken at any tome of the day.

Loading dose:

Loading is not absolutely necessary, it is only done to achieve results faster. Loading means taking doses more frequently to build up initial tan faster thus getting in tan maintenance mode sooner. Typical loading is done by taking 0.5mg once a day until desired skin tone is achieved. Loading dose can slightly vary from person to person, depending on skin type, bodyweight and other factors, but 0.5mg is pretty standard for most

Maintenance dose:

Maintenance doses are taken once the desired pigmentation has been reached and requires much less frequent dosing. Unfortunately, this is where too many variables come into play to give exact instructions. Skin type, bodyweight, metabolism regulating speed of skin fading, uv ray exposure, preferred tan level – all that makes impossible to give correct advice on maintenance dose. Everyone will find their own perfect dose and dosing frequency through some trial and error. To not leave you completely disinformed on this subject here is example of loading and maintenance which can be used as starting point where to adjust from:

Loading – 0.5mg a day with tanning session every 3rd day, desired skin tone achieved in 10 days.

Maintenance – 1mg once a week fallowed by tanning session.

Exposure to uv rays:

MT2 is not a completely sunless tanner. Users will still need some little uv ray exposure (whether from a tanning bed or actual sunlight) in order to build a tan. Without this exposure, the skin will not tan. Some people report being able to maintain their tan without sun exposure only by taking mt2 peptide, but this is arguable.

It should be noted that a tan can creep up unexpectedly. Tan generally sets in anytime up to 36h after exposure to UV rays, for this reason dosing should be done gradually and carefully.

Avoid Burning:

It is highly important to understand that MT2 itself does not protect skin from burning, tan protects your skin. Until some base tan is developed users should still take care not to over-expose skin to uv rays. Starting only with the amount of exposure that the user's skin can handle without burning. It should not take long before the user can handle longer exposures to strong sunlight without adverse effects.

MT-1 and MT-2

How does MT-1 compare to MT-2 ? In terms of darkening the pigmentation of skin to enhance and individuals tan, both types have been proven to work in a number of clinical trials. However, the side effects using MT-2 are more common, but offsetting this is the fact that the darkening effect using MT-2 can be seen faster. It's important to note that the dosages for Melanotan-1and Melanotan-2 are different. For example, a sometimes recommended beginning dose of MT1 is 1mg, while a beginning dose of MT2 is often only 0.25mg.

Where to buy real peptide ?
Contact COCO to get more info.
China@rawsgear.com
Whatsapp 8618186204104
Skype: Steroid-peptide